Conveyor belt is one of the important parts on the belt conveyor. Its life and quality almost directly determine the life of the belt conveyor and whether the conveyor line can run smoothly.
General conveyor belt splices commonly used methods include mechanical joints, cold bonded joints, hot vulcanized joints, etc. It is particularly important to choose a suitable conveyor belt joint method. Below we will mainly introduce these splice methods.
1. Mechanical splice method
Generally refers to the use of belt buckle joints. This joint method is convenient, convenient and economical, but the efficiency of the joint is low and it is easy to damage, which has a certain impact on the service life of the conveyor belt.
2.Heat vulcanization
The two ends of the rubber conveyor belt are layered with teeth, then the two ends are spliced together, and the heat gun is used for simple fixation. Put the assembled conveyor belt on the hot-melting equipment for heating and pressurizing to heat-melt. The temperature is about 140℃. After the cloth layer reaches the holding time, stop heating and let it cool to room temperature naturally. Remove the conveyor belt and it can be used normally. Up.
3 cold vulcanization
Clean the surface of the conveyor belt as required. After splicing it with a special chemical adhesive for the conveyor belt, apply pressure equalization and leave it for 24 hours before use.
For more information on rubber conveyor belts, please visit https://www.conveyorbeltforsale.com